APG4X, Password, Change
Contents
1 Introduction
1.1 Scope
2
Procedure
2.1 Prerequisites
2.2 Actions
3
Additional Information
4
Glossary
5
References
--------------------------------------------------------------------------------
1 Introduction
1.1 Scope
This Operational Instruction describes the procedure to change your APG40 user password.
--------------------------------------------------------------------------------
2
rocedure
2.1
rerequisites
2.1.1 Special Aids
No special aids are necessary for this procedure.
--------------------------------------------------------------------------------
2.2 Actions
Switch to AP Local Mode
Switch to AP local mode. See Operational Instruction AP, User Session, Initiate and return to Step 2 in this Operational Instruction.
Change Password
Change the password. Enter old and new password when promted for these.
password
Error?
Was the command execution aborted due to an error?
Yes
Go to Step 4.
No
Go to Step 5.
Try to solve the problem
Try to find a solution to the error using the manual pages. Was this possible?
Yes
Go to Step 2.
No
Contact next level of support.
Logout from the AP
Logout from the AP. Go to Operational Instruction AP, User Session, End and then return to Step 6 in this Operational Instruction.
Referred to from Another OPI?
Was this Operational Instruction referred to from another Operational Instruction?
Yes
Go to Step 7.
No
Go to Step 8.
Return to Referring OPI
Return to the Operational Instruction that referred to this Operational Instruction.
Job Completed
Make a report. See Operational Instruction Report of Finished Work and then return to Step 9 in this Operational Instruction.
The job is completed.
关注楼主