小弟最近在BSC调测，由于改IP后出了很多问题，所以只能克隆

小弟有几个疑问想请教各位大神

1.APG43克隆流程见附件，数据盘需要清空，系统盘DISK0需要清空吗？ 注：流程上说除WINPE盘不清以外，其他disk0,1,2都需要clean.
现在小弟已经把A边情况了。

2.上传完克隆包以后，下一步是确认NTSERV盘盘符，我的盘符显示大致如下
B边
volume 0CNTBOOT
volume 1DNTSERV
volume 2ENTBACKUP
volume 3FNTDUMP
volume 4GWINPE

A边
volume 0GDVD
volume 1HNTBOOT
volume 2FNTSERV
volume 3ENTBACKUP
volume 4DNTDUMP
volume 5CWINPE
所以询问，需要把NTSERV设置为C盘吗？
官方流程如下：

2 Start diskpart and check all volumes
x:\windows\system32\>diskpart
DISKPART>list volume
Volume Ltr Label Fs Type Size Status Info
------ --- -------- ----- -------- -------- ------ ----
Volume 0 Mirror 136 GB Healthy
Volume 1 Mirror 502 MB Healthy
Volume 2 G DVD-ROM 0 B Healthy
Volume 3 X WINPE FAT Partition 486 MB Healthy Boot
Volume 4 D NTBOOT NTFS Partition 5240 MB Healthy
Volume 5 C NTSERV NTFS Partition 20 GB Healthy
Volume 6 E NTBACKUP NTFS Partition 20 GB Healthy
Volume 7 F NTDUMP NTFS Partition 22 GB Healthy
3 Point to the NTSERV Volume and go to the following directory as in the
example below:
DISKPART>exit
cd /D C:\Program Files\AP\APOS\clone
NOTE: The NTSERV drive letter can be different from C.
Go to step 5.
If no drive letter is assigned to NTSERV partition, assign it performing the
procedure described in next step 4.
4 Assign drive letter to NTSERV
 start diskpart (command: diskpart)
x:\windows\system32\>diskpart
 Check which number NTSERV (specified in list volume printout)
partition has (let’s assume n).
 Select the volume (command: select volume n)
DISKPART>select volume <Volume No.>
 Assign a letter to the NTSERV drive (e.g. assign letter C
DISKPART>assign letter c:
 Exit diskpart (Command: exit).
DISKPART>exit
Note: Use command vol to check if connected to the right disk partition.
5 Run ConfigMenu.exe :
C:\Program Files\AP\APOS\clone>ConfigMenu.exe /preconfig

在第三步有这么一句话NOTE: The NTSERV drive letter can be different from C.
是需要把NTSERV改成C盘以后，再到第五步呢还是直接跳到第五步？

如果需要修改的话是只需要把NTSERV修改为C盘呢 还是按照C为NTSERVD为NTBACKUPE为NTBOOTF为NTDUMPX为winpe



急求各位大神指点，在线等。