射频单元连线到BTS存在问题，查看是否是耦合器的问题，这里这连线不一定是连错，也有可能是连线不紧，松动等问题，建议上站检查。
也有可能BTS数据做的有问题，检查连线等没问题，可以试着删创BTS数据。

[ 本帖最后由 yhyyby 于 2012-1-5 09:52 编辑 ]

学习来了，盼高人。

Manually defined RF cabling in SCF is incorrect as verified against BTS Configuration received from BSC; it may result in degraded BTS performance.
Remote:
1.Enable RF cable autodetection (RFCAD) through commissioning wizard.

Local:
1.Revise manually defined RF cabling in SIR (found in "cabling information" section) against the actual configuration.

Note: Rack field contains information check for cable present (1 = TX, 2=RX main, 3=RX Div, 4=both RX paths from same Ant connection).
Note: Shelf field contains the TRX number which contains Faulty RF cables.
Note: There may be more RF cabling errors introduced during commissioning, but only one of those is reported.
Note: If the DDU is shared across two sectors, a BCF reset is needed.
Refer to the latest Flexi EDGE BTS Commissioning document for RF cable auto-detection limitations.
上面是NED上查的，你自己看吧，我英文水平有限就不给你翻译了！

一般是射频电缆连接不良引起，也有可能是线路连接与数据不匹配

次要告警，不必处理！！！

BTS侧实际连线和BTS侧硬件数据库不一致，只要将其修改为一致就行了。我们这里有很多新开站和扩容站都出这样的告警。

BTS侧实际连线和BTS侧硬件数据库不一致

BTS侧实际连线和BTS侧硬件数据库不一致，一般是硬件数据没有做分级

路过 顶一下 支持楼主

检查BTS连线和硬件数据，核对BTS数据和BSC数据

7楼说得很正确，不影响性能，可忽略。

数据不匹配，重做硬件数据

学习下